International Antifouling VC Offshore High Performance 2 Lt Red
VC Offshore EU is an antifouling effective even in high fouling conditions, suitable for sailboats and motor boats. Quick drying to a hard and smooth film of paint, easy to clean and allows excellent sanding.
Smooth finish for increased speed and efficiency.
Hard film of paint easy to sand - ideal for sail and speedboats.
Quick and easy application.
Does not need sanding between coats.
Fast drying for rapid overcoating and flexible launch times.
APPLICATION AND USE:
OFFSHORE: Wash thoroughly with freshwater.
OTHER ANTIFOULING: Verify sound condition.
NATURAL GRP: Use VC General Thinner to clean and completely degrease the surfaces. Lightly sand using 240 grit sandpaper. Rinse with freshwater and allow to dry. Use VC Tar2 to prime and prevent osmosis.
STEEL: Prime with VC Tar2 to prevent corrosion.
LEAD: Prime with VC Tar2.
WOOD: Prime with Primocon.
Mixing: Stir well before use. Pour the dry ingredients (stored under the plastic cap) into the can. Stir or shake thoroughly. Cleaning solvent YTA600 VC General Thinner.
Airless spray pressure: 176-210 bar. Nozzle diameter: 1880-2180.
Conventional spray pressure: 2-3 bar. Nozzle diameter: 1,5-1,8 mm.
Other: For Airmix spray application: Pressure: 2 bar. Nozzle diameter: 20-113.
True colour will develop after immersion. It is important to apply the product quantity calculated on the basis of the spreading rate, and if necessary with an extra coat. It is also important to respect the thicknesses as advised to obtain the best results. To prevent poor result and performance, ensure the correct amount of paint is applied using the coverage as a guide (see spreading rate).
The temperature of the product should be between a minimum of 5°C/41°F and a maximum of 35°C/95°F. The ambient temperature should be between a minimum of 5°C/41°F and a maximum of 35°C/95°F. The surface temperature should be a minimum of 1°C above dew point and a maximum of 35°C.
Compatibility/Substrates: Suitable for use (with recommended primers) on GRP, steel, wood and Llead surfaces.
Apply 2-3 coats per season on the area to be coated. Apply an extra coat in areas subjected to greater wear such as rudders, sterndrives, keels, walk areas etc.
Coverage / spreading rate: (Theortetical) 11.7 m²/lt by roller -(Practical) 10.5 m²/lt by roller
Dry film thickness: Recommended per coat: 30 microns
Wet film thickness: Recommended per coat: 83 microns
Airless spray, conventional spray, roller.
- VC OFFSHORE (22 KB)
1Listing:€36.97Price:€27.73You Save:€9.24 (25%)
2Listing:€62.71Price:€47.03You Save:€15.68 (25%)