Cruiser 200 is a polishing antifouling product effective against fouling organisms; slime, aquatic plants and animals. A polishing antifouling suitable for application
onto vessels in fresh and salt water. The eroding technology avoids paint build up and provides up to one year performance. A range of bright colours including
a true white. Suitable for all substrates including aluminium.
Colour YBP200 White
Specific Gravity 1.4 g/l average
Volume Solids 52% average
Typical Shelf Life 2 yrs
VOC (As Supplied) 420 g/lt average
VOC (EU Solvent) 296 g/kg average EU Solvent Emissions Directive (Council Directive 1999/13/EC)
Unit Size 2.5 Lt
APPLICATION AND USE
PREVIOUSLY ANTIFOULED SURFACE:
In Good Condition: All fouling and contamination must be thoroughly removed including the leached layer. Use high pressure fresh water wash (3000 psi/207 bar) and/or scraping and wet sanding with typically 80120 grade paper. Do not dry sand. If old antifouling is incompatible or unknown, seal with suitable International Paint barrier/sealer coat.
In Poor Condition: Use Interstrip to remove all traces of antifouling.
PRIMING: All preparation for bare substrates is covered on the appropriate primer datasheet.
BARE GRP: Prime with Gelshield 200 for osmosis protection, or Primocon.
STEEL/IRON/LEAD/WOOD: Prime with Interprotect or Primocon.
PLYWOOD: Prime with Epiglass followed by Interprotect.
Hints Mixing: Thoroughly stir until product is mixed to a uniform consistency before use.
Thinning: Thinning is not recommended. Antifouling performance can be compromised if correct dry film thickness is not applied.
Cleaner: YTA085 International Antifouling Thinners #3.
Airless Spray Pressure 176220 bar/25003200 psi. Tip Size: 2180.
Ventilation and Humidity Control: Ensure adequate ventilation during use.
Other: Antifoulings should only be wet sanded. Never dry sand or burnoff old antifoulings. True colour will develop after immersion.
Packing of 2.5lt.